Part 2

Multimedia system, RSE, two screens, with two players























INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Multimedia system, RSE, two screens, with two players

Applies to all models




- Tape the cables to the cable tie.





- Place the head restraint in the seat.

Note! The cables must be in front of the head restraint tube.





- Push the head restraint in to place at the same time as feeding the cables forward.






Caution! Check that the head restraint has locked into place by pulling it upwards.





- Using your fingers, press the cables under the protection. The cables must not press out the upholstery after installation.
Padding (1)
Protective pad (2)

Note! The image shows a seat without upholstery.





- Pull the cable tie with cables through the hole and out at the lower edge.
- Remove the cable tie and tape from the cable harness.





- Pull the cables forward and in under the seat. Follow the existing cable.
- Secure the cables using three cable ties
- Reinstall the lumbar adjustment.

Note! The image shows a seat without upholstery.





- Place the seat in the vehicle.





- Connect the 2-pin connector.





- Connect the green connector.
- The groove and the arrow should stand directly opposite each other.





- Connect the black connector.
- The groove should stand directly opposite each other.





- Install the connector casings.





- Install cable ties around the connector casings.














- Repeat the method steps for the other seat.
- Reinstall the detached components in reverse order.





- Reconnect the battery negative lead






Warning! When the ignition is to be switched on for the first time after the battery has been disconnected, this must be done whilst by standing outside the vehicle, stretching your arm in and avoiding the working area for the airbags.

- Set the ignition switch to position II.





- Install the batteries in the remote control and headsets.
- Region code the DVD players. Information is available in VIDA under:
- Product specifications
- Design and Function
- 3 Electrical system
- 39 Media - communication and entertainment
- 393 Equipment for entertainment
- Rear seat entertainment system
- Design
- Place remote controls, headsets, wiring and quick-guide in a suitable place in the vehicle.