USB/IPod Music Player, Interface, Cradle

USB/Ipod Music Player, Interface, cradle























INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






USB/Ipod Music Player, Interface, cradle

Applies to the S40, V50, C30 and C70










Positioning applies to left-hand drive cars





Applies to left-hand drive cars
- Position the cradle against the rear end.





Applies to left-hand drive cars





Applies to right-hand drive cars





Applies to right-hand drive cars
- Position the cradle in the middle of the side face.





Applies to right-hand drive cars





Applies to all models
- Mark and make holes using a scriber or similar.

Caution! The hole must not be larger than 2 mm.

Applies to the XC90










- Position the cradle in the tunnel compartment's front end.










Applies to cars with DVD player (RSE)
- Position the cradle on the rear end in the tunnel console.





Applies to cars with DVD player (RSE)





Applies to all models
- Mark and make holes using a scriber or similar.

Caution! The hole must not be larger than 2 mm.

Applies to the V70, XC70 and S80










Applies to left-hand drive cars
- Position the cradle on the right-hand long side against the rear end.





Applies to left-hand drive cars





Applies to right-hand drive cars and cars with DVD players (RSE)





Applies to right-hand drive cars and cars with DVD players (RSE)





Applies to all models
- Mark and make holes using a scriber or similar.

Caution! The hole must not be larger than 2 mm.

Applies to the XC60










Applies to left-hand drive cars and right-hand drive cars with car phones
- Position the cradle on the right-hand long side against the rear end.





Applies to left-hand drive cars and right-hand drive cars with car phones





Applies to right-hand drive cars
- Position the cradle on the left-hand long side against the front end.





Applies to right-hand drive cars





Applies to all models
- Mark and make holes using a scriber or similar.

Caution! The hole must not be larger than 2 mm.

Applies to all models





- Slacken off the screws.





- Remove the end.





- The marking on the connector must be pointing outwards.





- Press in the catches and connect the connector.





- Install the rear and the screws.





- Connect the connector with the marking pointing outwards.





- Install the screw.





- Screw the cradle in the tunnel compartment.
- Try to feed in any excess wiring.