Part 2
Parking assistance, rear
INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.
Parking assistance, rear
Applies to the left-hand side
- Ensure that the marking on the hole tool (LH) and the marking that was made on the bumper cover are opposite each other.
Note! Ensure that the support sleeve does not turn when the screw is tightened.
Applies to the right-hand side
- Ensure that the marking on the hole tool (RH) and the marking that was made on the bumper cover are opposite each other.
Note! Ensure that the support sleeve does not turn when the screw is tightened.
- Clean the inside of the bumper cover using a mild soap solution.
- Clean an area around the holes that is slightly larger than the sensor holder. Use isopropanol. Allow to dry.
- Clean using isopropanol.
- Clean using isopropanol.
- Apply a thin and even layer of activator. Allow to dry for at least 10 minutes.
- Use: 8637076 Activator.
- Apply a thin and even layer of activator. Allow to dry for at least 10 minutes.
- Use: 8637076 Activator.
- Locate the taped connector and connect it to the control module.
- The cable harness will not be used again.
- Apply two pieces of tape.
- Remove the protective film from the tape.
- Apply a thin and even layer of adhesive. The adhesive must be above the tape level.
- Use: 9512950 Adhesive gun, 1161730 Mixing pipe and 9511027 Adhesive.
Caution! The adhesive must not come into contact with the tape.
- Press the holder towards the casing, but only at the places where there is tape.
- Hold the cradle securely when removing the centering tool.
- Repeat the method steps on the other cradle.
- Apply two pieces of tape.
- Remove the protective film from the tape.
- Apply a thin and even layer of adhesive. The adhesive must be above the tape level.
- Use: 9512950 Adhesive gun, 1161730 Mixing pipe and 9511027 Adhesive.
Caution! The adhesive must not come into contact with the tape.
- Repeat the method steps on the other cradle.
Note! Connect the painted sensors in the middle.
- Reinstall the detached components in reverse order.
- Download the software for the accessory's function.