Part 3

Parking assistance, camera, rear

Equipment






























Kit contents













Vehicles with 5 inch ICM-display





Note! If the connection is missing the display must be replaced.





All vehicles





Note! The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Connect the connectors.

Vehicles with 5 inch ICM-display




Connect the connector.

Vehicles with 7 inch display




Connect the connector.

All vehicles








Install the screws.





Note! The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Connect the connectors.








Install the screws.












Fold the carpet to the side.




Locate the existing connectors in the vehicle's cable harness.





Caution! Make sure that no part of the wiring harness is trapped.

Fold the floor carpet back.








Install the screws.




Connect the connectors.








Reinstall the removed parts in reverse order.




Set the ignition key to position II.




Download software (application) for the accessory's function. See VIDA or the accessories catalogue for software part number.

Calibrate according to: Service calibration, parking camera