Fault-Tracing Information

Fault-tracing

Fault-tracing information

Note! This trouble code is only relevant for troubleshooting and action in the following cases:

- The trouble code is active in the present driving cycle and has been active for a longer period of time.
- The customer experiences malfunction that can be attributed to the trouble code.
In other cases, the DTC does not indicate a fault and must therefore be ignored and only erased.

Do you want to continue fault-tracing?

Yes - Checking fuses and power supply

No - DONE

-------------------------------------------------

Checking fuses and power supply




The remote digital audio receiver (RDAR) is suppled power from the central electronic module (CEM) via a fuse.
Check if the fuse for the Remote Digital Audio Receiver (RDAR) is half burned by testing with a new fuse.

Hint: A half burned fuse can cause intermittent faults.

- Ignition on.
Check the supply voltage to the Remote Digital Audio Receiver (RDAR) by:
- Measure the voltage between control module connectors #C1-1 and #C1-2.
- Measuring the battery voltage.
If the difference between the control module's supply voltage and the battery voltage is greater than 2 V, the malfunction is in the supply cable.
If the difference is less than 2 V there may be an internal malfunction in the control module.
- Remedy as necessary.

Other information
- For further information about the fuses and relays, see the Wiring Diagram
- Location of components Component Location, Remote Digital Audio Receiver (RDAR)
- Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring and Terminals
- Satellite radio control module Satellite Radio Control Module

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the radio is working and that the reception is acceptable.

Is the radio playing through the loudspeakers?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking fuses and power supply

-------------------------------------------------