Fault-Tracing Information

Fault-tracing

Fault-tracing information

Note! This trouble code is only relevant for troubleshooting and action in the following cases:

- The trouble code is active in the present driving cycle and has been active for a longer period of time.
- The customer experiences malfunction that can be attributed to the trouble code.
In other cases, the DTC does not indicate a fault and must therefore be ignored and only erased.

Do you want to continue fault-tracing?

Yes - Fault-tracing information

No - DONE

-------------------------------------------------

Fault-tracing information
Use the following information and general checks during fault-tracing.

Note! Check that the fuses are intact. For locations, see the instruction manual, cover for fuse box, fuse ratings or similar.

1. Check, if possible, relevant functions in the vehicle using buttons/controls/test drives to determine the status of the fault.

Note! If the vehicle does not show any of the given symptoms in the diagnostic trouble code information (DTC), this may mean that the fault is intermittent or that the control module is not detecting the fault at this moment.

2. Use the diagnostic trouble code's frozen values, status identifiers and counter to determine the operating conditions when the fault was detected, the fault's current status and any degree of intermittence of the fault.
3. Check and fault-trace according to the fault causes that are specified in the diagnostic trouble code (DTC) information.
4. Use VIDA Vehicle communication. Read off the parameters, activate components and functions, carry out quick tests and checking routines for the diagnostic trouble codes to identify the fault.
5. Check relevant components according to Component specifications.
6. Check relevant signals using wiring diagram, signal specification and breakout box.

Note! More information is available in Design and function.

Remedy as necessary.

Other information
- Description of frozen values Description of Frozen Values, IAM
- Description of status identifier Description of Status Identifier
- Description of counter Description of Counter
- Component location, Integrated Audio Module (IAM) Component Location, Integrated Audio Module (IAM)
- Connecting the breakout box Connecting the Breakout Box, Integrated Audio Module (IAM)
- Signal description, Integrated Audio Module (IAM) Signal Description, Integrated Audio Module (IAM)
- Checking the supply voltage/ground terminal Component Tests and General Diagnostics
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Verification




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------