Fault-Tracing Information

Fault-tracing

Checking the wiring and terminals




- Ignition off, wait for 15 seconds.
Check the charging function of the generator (GEN).
Check the battery voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Fault-tracing and testing the battery Fault-Tracing and Testing the Battery
- Checking the supply voltage/ground terminal Checking Supply Voltage/Ground Terminal, Supplemental Restraint System Module (SRS)
- Cable harness SRS system, repair Cable Harness SRS System, Repair
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Verification

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the wiring and terminals

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------