Fault-Tracing Information

Fault-tracing

Replacing a component
The Forward Sensing Module (FSM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the Forward Sensing Module (FSM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault recurs, try downloading new software to the control module. If this does not help, replace the Forward Sensing Module (FSM).
In the event of a permanent fault, try downloading new software to the control module. If this does not help, replace the Forward Sensing Module (FSM).

Remedy as necessary.

Other information
- Collision warning control module, L.H.D Service and Repair
- Software, downloading





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT FOUND - DONE

Attempt New Test - Replacing a component

-------------------------------------------------