Fault-Tracing Information
Fault-tracing
Checking diagnostic trouble codes (DTCs)
If DTC TCM-P088513 is stored in the Transmission control module (TCM), it must be troubleshooted first as it can be the root cause of why the DTC is stored.
If DTC TCM-P088513 is not stored, press continue.
Continue - Checking the function
-------------------------------------------------
Checking the function
- Ignition on.
- Gear selector in position P
- Try moving the gear selector to another position without depressing the brake pedal. It should not be possible to move the gear selector.
- Depress the brake pedal and try moving the gear selector to another position. It should now be possible to move the gear selector.
If the function is correct, this is an indication that the fault was present previously but is not active at the moment, i.e. an intermittent fault.
Continue - Checking the wiring and component
-------------------------------------------------
Checking the wiring and component
- Ignition off.
Check the cable between transmission control module (TCM) terminal #13 (#A43) and gear selector module (GSM) terminal #3 for open circuit and short circuit to ground.
Hint: With the ignition on, the voltage when the gear selector is in N must be 0 V. It should be Ubat when the gear selector is in position R or D.
Other information
- Breakout box, connecting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Connecting Breakout Box, Transmission Control Module (TCM)
- To access connector A: Transmission Control Module (TCM), B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Transmission Control Module (TCM)
- Signal specification, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Signal Specification, Transmission Control Module (TCM)
- Checking wiring and terminals Checking Wiring and Terminals
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Gear selector in position P.
Try moving the gear selector to another position without depressing the brake pedal. It should not be possible to move the gear selector.
Depress the brake pedal and try moving the gear selector to another position. It should now be possible to move the gear selector.
Was the function OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFICATION FAILED - Fault-tracing information
VERIFIED - FAULT FOUND
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the function
-------------------------------------------------