Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P096000

Condition
Linear pressure solenoid SLT controls system pressure in the transmission. The solenoid is controlled by power stages at the output of the transmission control module (TCM).
The transmission control module (TCM) uses the power stage to control the current to the solenoid. A low amperage results in a high line pressure. A high amperage (approximately 1 A) gives a low line pressure. The amperage is primarily affected by the throttle position.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Open circuit in solenoid SLT circuit.
Solenoid SLT cannot then control the line pressure.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Auxiliary program Emergency mode 3 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Emergency Mode In Case of Malfunction

Possible source
- Contact resistance in the terminals.
- Open-circuit in the cable for the control signal or signal ground.
- Linear pressure solenoid SLT not working.

Fault symptom[s]
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication
- Automatic transmission/Lockup does not work
- Automatic transmission/No automatic gearshift
- Text window and warning symbol/Yellow symbol and text message
- Automatic transmission/No manual gear shift
- Automatic transmission/Shifts rough or jerky/Unsure when/at all times
- Driving/Poor performance/lacks power