Fault-Tracing Information

Fault-tracing

Calibrating the position sensor in the control module




- Check that the gear selector cable is correctly adjusted. Adjust if necessary.
- Ignition on.
- Place the gear selector lever in neutral position (N).
Activate calibration of the position sensor in the control module by clicking on the VCT2000 symbol.

Other information
- Gear selector cable, adjusting, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Adjustments









Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Calibrating the position sensor in the control module

-------------------------------------------------

Verification




- Ignition off.
- Wait two minutes.
- Ignition on.
- Move the gear selector several times to all gear positions.
- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
If present code diagnostic fault code (DTC) remains stored replace the transmission control module (TCM).

Other information
- Transmission Control Module (TCM), B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC, B6324S4, TF-80SC AWD, B6324S4, TF-80SC Transmission Control Module (TCM)









Is the relevant diagnostic trouble code (DTC) still stored?

Yes - Fault-tracing information

No - FAULT FOUND

-------------------------------------------------