Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition
The brake control module (BCM) with hydraulic unit supplied calibrated from the factory.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Brake control module (BCM) has no calibration data.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Current brake control module (BCM) that is installed has no calibration data.

Fault symptom[s]
- Information lamp is on