Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information KVM-B10D224

Condition
When the lock button on the door handle is depressed, a switch is activated and a counter starts.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Lock button has been activated for longer than 2 minutes.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Activation of the lock button.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Damaged switch.
- Lock button depressed for longer than 2 minutes.
- The signal cable is short-circuited to ground.

Fault symptom[s]
- Not possible to lock with outer lock button