Fault-Tracing Information

Fault-tracing

Select an alternative
- If the diagnostic trouble code (DTC) is permanent: Select alternative 1.
- If the diagnostic trouble code (DTC) is intermittent: Select alternative 2.

Select an alternative.

1 - Checking components and connections

2 - Intermittent fault

-------------------------------------------------

Intermittent fault




- The fault has been remedied.

Continue - Verification

-------------------------------------------------

Fault-tracing information

Attempt New Test - Select an alternative

-------------------------------------------------

Checking components and connections

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!








- Ignition off, wait for 15 seconds.
The supplemental restraint system module (SRS) detects that the front right-hand side impact sensor is connected to the control module.
The front right-hand side impact protection (SIPS) bag must not be connected to the supplemental restraint system module (SRS).
- Remove the connector/component.

Other information
- For further information, see the wiring diagram.
- Air bag, front seat Air Bag, Front Seat

Continue - Powering the SRS system

-------------------------------------------------

Powering the SRS system




Powering the SRS system

Powering the SRS system

Warning! Nobody should be in the passenger compartment when the SRS (supplemental restraint system) is first powered after fault-tracing/repair.

Caution! Ignition off during the entire procedure.








- Reinstall the connectors, components etc.
- If the battery negative lead has been removed: Connect the battery negative lead.
When powering up the SRS-system, other systems and components in the vehicle will also be activated.
Power the SRS (supplemental restraint system) by clicking the VCT2000 symbol.
Performing the service may take up to 15 seconds.





Continue - FAULT FOUND

------------------------

FAULT FOUND - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------