Part 2

Note! During installation the underlying surface must be kept at a temperature of at least +15°C (59°F).

- Insert the trim strip clips in the corresponding holes on the panel. Ensure that the strip's locating pins align with the holes on the trunk lid.
- Press the strip firmly along the entire length of the trunk lid and the panel so that the tape adheres.





- Connect the number plate lighting connector on the inside of the trunk lid.





- Reinstall the panel on the inside of the trunk lid.





- Reinstall the warning triangle's holder and press the middle pins of the clips in.





- Take the new inner handle from the kit and press it onto the boot lid.
- Refit the warning triangle holder and the warning triangle on the boot lid.

Installing the parking assistance camera (PAC)





- Take the control module from the kit.
- Clean the two polished surfaces on the control module using isopropanol.
- Wipe dry.





- Take two Velcro strips from the kit and cut them in the middle to create four equal parts.





- Press the Velcro strips two and two.





- Remove the protective film from one side of the two attached Velcro strips.





- Press the Velcro strips onto the cleaned surfaces of the control module.





- Clean the surfaces under the tail lights with isopropanol. Wipe dry.


Note! The adapter cable A was included in a previous version of the kit for the parking camera.The adapter cable B was included in a later version of the kit for the parking camera.Both versions are suitable for all cars.

Illustration A




- Connect the previously routed cable harness connector (1) to the right-hand connector on the control module.
- Take the adapter cable A/B from the kit and connect the large green connector to the socket on the control module, as illustrated.
- Connect the connector (2) on the pre-routed, taped cable harness for the power supply under the left-hand tail lamp, to the corresponding connector on the adapter cable.
- Take the long remaining cable harness from the kit and connect the end with the gray connector (3) to the connector in the middle of the control module.
- Clamp the adapter cable's remaining connector using the tie strap from the kit.

Figure B shows adapter cable A





Figure C shows adapter cable B









- Remove the protective film from the installed Velcro strips.





- Press the control module upwards firmly as high as possible on the flat surface under the tail lamp, according to the measurements illustrated.

Applies to cars with a TRM module.




- Remove the two connectors from the top of the TRM module.
- Remove the TRM module from the Velcro strips on the plate under the rear lamp and place to one side.





- Allow the old Velcro strips to remain in the body.





- Remove the protective film from the Velcro strips.





- Press the Velcro strips on to the cleaned surfaces on the parking assistance camera (PAC).


Note! The adapter cable A was included in a previous version of the kit for the parking camera.The adapter cable B was included in a later version of the kit for the parking camera.Both versions are suitable for all cars.

Figure A shows adapter cable A





Figure B shows adapter cable B




- Connect the previously routed cable harness connector to the right-hand connector on the control module (1).
- Take the adapter cable A/B from the kit and connect the large green connector to the socket on the control module, as illustrated.
- Connect the connector (2) on the pre-routed cable harness for the power supply to the corresponding contact on the adapter cable.
- Take the long remaining cable harness from the kit and connect the end with the gray connector (3) to the connector in the middle of the control module.





- Press the control module firmly onto the existing Velcro straps under the tail lamp.





- Clean the marked surfaces on the control module with isopropanol. Wipe dry.





- Remove the marked Velcro strip from the TRM module.





- Take two Velcro strips from the kit and cut them in the middle to create four equal parts.