Engine Body, Exposing

Engine body, exposing

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Loosen the lower screws (these are difficult to access) between the transmission/engine before removing the engine/transmission unit. Place the engine and transmission unit on a suitable surface.
Relieve the transmission. Loose the remaining screws and carefully remove the transmission.


Remove the following items:
- Carrier plate
- Crankshaft position sensor (CKP). Refer to: Crankshaft position sensor (CKP), B5254T5, TF-80SC Service and Repair
- exhaust manifold. Refer to: Exhaust manifold, B5254T5 Service and Repair
- ignition coils. Refer to: Ignition coil, B5254T5 Service and Repair
- intake manifold. Refer to: Induction pipe, B5254T5, TF-80SC Service and Repair
- oil cooler. Refer to: Oil cooler, engine, B5254T5 Service and Repair
- generator. Refer to: Generator, B5254T5 Service and Repair
- thermostat. Refer to: Thermostat, B5254T5 Service and Repair
- camshaft sensor. Refer to: Camshaft position sensor (CMP), B5254T5 Service and Repair
- knock sensor. Refer to: Knock sensor (KS), B5254T5 Service and Repair
- tensioner auxiliary unit belt. Refer to: Accessory Drive Belt Tensioner, B5254T5, TF-80SC Service and Repair
- injector. Refer to: Fuel injector, B5254T5 Service and Repair
- VVT-solenoid. Refer to: VVT solenoid, B5254T5 Service and Repair


Install the following items:
- 999 2520 FLOOR STAND 999 2520 Floor Stand
- 999 5297 ENGINE FIXTURE 999 5297 Engine Fixture
- 998 9721 SCREW SET 998 9721 Screw Set
Installing engine in stand