Fault-Tracing Information

Fault-tracing

Information
The immobilizer function is integrated in the central electronic module (CEM).
This diagnostic trouble code (DTC) may be due to missing CAN communication. If there is a diagnostic trouble code (DTC) stored in the central electronic module (CEM) fault trace accordingly.

Note! An unprogrammed central electronic module (CEM) does not have a code for the immobilizer, which can result in this diagnostic trouble code (DTC) being stored.

If no diagnostic trouble codes (DTCs) are stored in the central electronic module (CEM), try a new central electronic module (CEM).

Other information:
- Signal specification, B5254T5 Signal Specification, Engine Control Module (ECM)
- Engine control module (ECM), B5254T5 Service and Repair

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Information

-------------------------------------------------