Fault-Tracing Information

Fault-tracing

Checking components
Check that the engine speed (RPM) sensor is correctly installed.
Check the engine speed (RPM) sensor. Check that it is not damaged or dirty.

Hint: The diagnostic trouble code (DTC) can be caused by damage in the flywheel / carrier plate. Look for damage to the flywheel / carrier plate.

Other information
- Crankshaft position sensor (CKP), B5254T5, TF-80SC Service and Repair





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, reinstall components etc.
- Start the engine. The fault has not been remedied if the engine does not start.
Read off the diagnostic status and fault status for the diagnostic trouble code (DTC) by selecting the relevant diagnostic trouble code (DTC) from the list.
Increase the engine speed to 2500 rpm until the diagnostic is "Complete".
Check the fault status for the diagnostic trouble code (DTC) when the diagnostic is "Complete". If the function is correct, the fault status must be "No fault found" when the diagnostic is complete.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking components

-------------------------------------------------