Engine, Removal

Operation number: 21014-0

Engine, removal

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Drain the fuel system. Refer to: Fuel system pressure release, B6304T4, B5254T5 Fuel System Pressure Release.

Drain the cooling system. Refer to: Cooling system - draining, charging and bleeding, B6304T4 Service and Repair.

Remove the following items:
- accessory drive belt. Refer to: Accessory Drive Belt, B6304T4 Service and Repair
- engine control module (ECM). Refer to: Engine control module (ECM), B6304T4 Service and Repair
- exhaust manifold. Refer to: Exhaust manifold, B6304T4 Service and Repair
- left driveshaft. Refer to: Driveshaft left, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Driveshaft Left
- right drive shaft. Refer to: Drive shaft right, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Drive Shaft Right
- subframe. Refer to: Front subframe, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Service and Repair
- bevel gear. Refer to: Bevel gear, B6304T4, TF-80SC AWD Bevel Gear

Warning! Be prepared to collect escaping fluids.

Ensure that the lifting table is centered under the engine/transmission for optimal weight distribution. Check that the lifting table is correctly positioned.
Secure the engine / transmission in the lifting table with a retaining strap.
Open the cock for the hydraulic modulator for the lifting table. Ask a colleague to help. Lower the vehicle at the same time as opening the lifting table compressed air unit.
Stop the vehicle immediately before the lifting table reaches its lower position. Close the cock for the hydraulic modulator for the lifting table.

Remove the following items:
- right-hand engine mounting. Refer to: Engine support insulator, right, B6304T4, TF-80SC AWD Engine Support Insulator, Right
- left-hand engine mounting. Refer to: Engine support insulator left, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Engine Support Insulator Left

Caution! Make sure that no components catch when raising the car.

Raise the car.