Diagnostic Functions

Diagnostic functions

General
The control module has an integrated diagnostic system, which continuously monitors its own system as well as the input and output signals.

Diagnostic trouble codes (DTCs)
A diagnostic trouble code (DTC) is stored if the control module detects a fault. A fault which is detected in the most recent operating cycle is defined as permanent. Other faults are defined as intermittent. An operating cycle involves ignition on, the vehicle speed exceeding 20 km/h and the ignition being switched off.

Reading out and erasing diagnostic trouble codes
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function.

Reading off input and output signals
This function can be used to continuously read off the status of the control module's input and output signals.
For more information about parameters, see Vehicle communication information in Specifications, other.

Activating components
This function can be used to activate components to check that they are working.
For more information on activations, see Vehicle communication information under Specifications, other.

Reading off the control module identification
The diagnostic tool identifies control modules by reading off a number of codes from the control module memory.
The codes contain the following information about the control module:
- hardware P/N (control module without software)
- hardware serial number (control module without software)
- software P/N
- diagnostic software P/N (part of the software).