Diagnostic Functions

Diagnostic functions

General
The control module has a built-in diagnostic system, Volvo Diagnostic, which continuously monitors internal functions as well as input and output signals.

Diagnostic trouble codes (DTCs)
If the control module detects a fault, a diagnostic trouble code is stored. A fault that was detected during the last driving cycle is defined as permanent. Other faults that are detected are defined as intermittent.

Reading and erasing diagnostic trouble codes (DTCs)
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function. Diagnostic trouble codes (DTCs) can only be erased once all the diagnostic trouble codes (DTCs) have been read off at least once.

Reading off the parameters
This function is used to read the status or value of parameters. The status or value can be presented digitally.
For more information, see Vehicle communication information in Specifications, other.

Activating components and functions
This function can be used to activate components/functions which affect the Infotainment control module (ICM).
For more information, see Vehicle communication information in Specifications, other.

Reading off static data
This function allows programmed data to be read off or data such as customer parameters to be programmed in.

Reading off the control module identification
The diagnostic tool identifies control modules by reading off a number of codes from the control module memory.
The codes contain information about the control module:
- hardware P/N (control module without software)
- hardware serial number (control module without software)
- software P/N
- diagnostic software P/N.

Reading off extended fault-tracing information
This function can be used to read out parameters, identify status and counts stored at the same time as a diagnostic trouble code (known as frozen values).
For more information, see Vehicle communication information in Specifications, other.