Connecting the Breakout Box, Forward Sensing Module (FSM)

Connecting the breakout box, Forward Sensing Module (FSM)

Special tools:
951 3013 FSM-adapter 951 3013 FSM-Adapter
951 1428 Breakout box 951 1428 Breakout Box

Caution! Avoid touching control module connector pins and corresponding cable harness connectors. There is a risk of electrostatic discharge, which could damage the control module. Relieve any charge on yourself and the tools to be used by holding the metal part of the tool and touching part of the body just before starting work.

General information
Visually check the connectors to ensure that the male and female terminals are not damaged and that the cables for the female halves are properly connected.
The breakout box is designed to facilitate reading off control module output and input signals when the control module is connected as well as resistance of cables and components when the control module is disconnected. Using a breakout box reduces the risk of unintentionally short-circuiting cables or damaging connector pins.

Breakout box, connecting
- Ignition off
- For information on releasing the forward sensoring module (FSM) connector, see Collision warning control module, L.H.D Service and Repair
Connect the breakout box 951 1428 Breakout box 951 1428 Breakout Box and cable harness 951 1499 Cable 951 1499 Cable to the adapter.

Forward Sensing Module (FSM)
- Connect the adapter 951 3013 FSM-adapter 951 3013 FSM-Adapter to control module connector C1.
- For connector C1, terminals #C1:1-#C1:30 correspond to terminals #1-#30 on the breakout box.

Note! Before the control module can be checked and readings taken, the removed fuses must first be refitted.

Other information
- For further information on signals and other values, see Signal description Signal Specification, Forward Sensing Module (FSM)
- For further information on fuses and grounding points, see the relevant wiring diagram.