Part 1

Parking assistance, rear

INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Parking assistance, rear

Note! Some steps in these installation instructions are presented with illustration only.

Applies when installing on cars with skid plates
For information about installing the two inner sensor cradles, see installation instructions: 31265633

- Clean the sensors. Use: Isopropanol
- Allow to dry.

- Carefully mat the surface down. Use: sandpaper, grade P1000

- Clean the sensors again. Use: Isopropanol.
- Allow to dry.
- Avoid contact with the cleaned surfaces.

Caution! Protect the connections' contact surfaces against paint.

- Paint the sensors in the same colour code as the vehicle.
- Use Volvo Touch-up paint (Only use base coat.)
- Use: Volvo 2-K Varnish. P/N: 31335447.

Note! Also read the instructions on the spray can.

Caution! The paint must have dried after the first application.

- Turn the ignition key to position 0.

Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.