Fault-Tracing Information

Fault tracing

Checking the battery and connections
Check the battery.
Check the battery terminals and the engine control module (ECM) connector. Check for contact resistance, play and oxidation.

Continue - Replacing the component

-------------------------------------------------

Replacing the component
The engine control module (ECM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults may be due to interference at start or may be a different type of fault that occurs on different occasions. The fault is evaluated depending on how it occurs.
Ensure that the software in the Engine control module (ECM) is correct by downloading it again.
If the fault recurs, replace the control module.
In the event of a permanent fault, replace the control module.
Remedy as necessary.

Other information
- Engine control module (ECM), B6304T4 Service and Repair





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT FOUND - DONE

Attempt New Test - Checking the battery and connections

-------------------------------------------------