Fault-Tracing Information

Fault-tracing

Information
Select the DIAGNOSTICS/COMPONENTS tab and check that the vehicle's configuration data corresponds with the vehicle's configuration.
If the vehicle's configuration data corresponds with the vehicle's configuration, this means that the Transmission control module (TCM) may have incorrect configuration data. Select the SOFTWARE tab and reprogram the Transmission control module (TCM) with the latest software.
If the vehicle's configuration data does not correspond with the vehicle's configuration, this means that the Central electronic module (CEM) may have the incorrect configuration data. Select the SOFTWARE tab and reprogram the Central electronic module (CEM) with the latest software.





Continue - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------

Checking the diagnostic trouble codes (DTCs)




- Ignition off for 10 seconds and then on again.
- Read off diagnostic trouble codes (DTCs).









Was the relevant diagnostic trouble code (DTC) still stored?

Yes - Fault-tracing information

No - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Information

-------------------------------------------------