Diagnostic Trouble Code Information

Diagnostic trouble code (DTC) information PSCM-U041868

Condition
The control module is continuously supplied with information about the vehicle's speed from the Brake control module (BCM) via CAN-communication. The control module checks the quality of the information from the Brake control module (BCM).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Information from Brake control module (BCM) is incorrect/unreasonable.
- Incorrect value lasts longer than 2 seconds.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.
- Battery voltage between 9 - 18 V.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- The vehicle speed signal is set as a default value.

Possible source
- Fault-trace in transmitting control module.

Fault symptom[s]
- Abnormally light steering at high speed
- Abnormally sluggish steering at low speed
- Steering/Other steering/handling problems