Fault-Tracing Information

Fault-tracing

Fault-tracing

Note! If diagnostic trouble codes (DTCs) DIM-U001000 or DIM-U030000 are detected, fault trace according to these before fault tracing this diagnostic trouble code.

Troubleshoot as follow:
- Check that the fuses are intact.
- Check the connectors and cables.
- Fault-trace the transmitting control module (Infotainment control module (ICM)).
- Check the control area network (CAN). Check for an open-circuit. Check for a short-circuit.
- Replace the Driver information module (DIM).

Other information:
- Location of components Locations
- Signal specification, Driver information module (DIM) Signal Specification, Driver Information Module (DIM)
- Connecting the breakout box Connecting the Breakout Box, Driver Information Module (DIM)
- For information about fuses, see the wiring diagram.





Continue - Verification

-------------------------------------------------

Verification

Note! After carrying out the repair, check that the fault has been remedied.

- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Is the fault intermittent?

Yes - FAULT FOUND

No - Information

-------------------------------------------------

Information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Fault-tracing

-------------------------------------------------