Fault-Tracing Information

Fault-tracing

Checking communication




- Ignition off.
Fault-trace the driver information module (DIM).
Remedy as necessary.

Other information
- For further information, see the wiring diagram.
- General information about fault-tracing in the CAN network Initial Inspection and Diagnostic Overview
- Checking wiring and terminals Checking Wiring and Terminals. Permanent Faults

Continue - Verification

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking communication

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------