Fault-Tracing Information

Fault-tracing

Information
No fault-tracing has been developed for this diagnostic trouble code (DTC).
The diagnostic trouble code (DTC) for CAN communication can also be stored in the central electronic module (CEM). In certain cases the diagnostic trouble code (DTC) is stored in other affected control modules. This diagnostic trouble code (DTC) must not be erased until any diagnostic trouble codes (DTCs) in the central electronic module (CEM) for CAN communication and in the brake control module (BCM) have been remedied and erased.
First read off the diagnostic trouble codes (DTCs) in the central electronic module (CEM) and the brake control module (BCM). Fault-trace and remedy as necessary. If no diagnostic trouble codes (DTCs) are stored, fault-trace the controller area network (CAN) as follows. This diagnostic trouble code (DTC) can then be erased.
For further information on this diagnostic trouble code, see Diagnostic trouble code (DTC) information.

Other information
- General information about fault-tracing in the CAN network Initial Inspection and Diagnostic Overview





Continue - DONE

-------------------------------------------------