Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P273800

Condition
Linear pressure solenoid SLC1 controls system pressure in the transmission. The solenoid is controlled by power stages at the output of the transmission control module (TCM). The control module uses the power stage to control the current to the solenoid. A low amperage results in a high line pressure. A high amperage (approximately 1A) results in a low line pressure. The amperage is primarily affected by the throttle position.
The diagnostic trouble code is stored if the control module detects:
- An open circuit in solenoid SLC1 circuit.
Then Solenoid SLC1 cannot control the system pressure.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Auxiliary program Emergency mode 1 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Emergency Mode In Case of Malfunction

Possible source
- Contact resistance in the terminals.
- Open-circuit in the cable for the control signal or signal ground.
- Short-circuit to ground in the signal cable.
- Linear pressure solenoid SLC1 not working.
- The transmission control module (TCM) does not function.

Fault symptom[s]
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication
- Automatic transmission/Shifts rough or jerky/Unsure when/at all times
- Automatic transmission/No automatic gearshift
- Automatic transmission/Lockup does not work
- Text window and warning symbol/Yellow symbol and text message
- Automatic transmission/No manual gear shift
- Driving/Poor performance/lacks power