Fault-Tracing Information

Fault-tracing

Information
No fault-tracing has been developed for this diagnostic trouble code (DTC).
A diagnostic trouble code for CAN communication can be stored in the central electronic module (CEM). IN some cases, a diagnostic trouble code is stored in other affected control modules. This diagnostic trouble code is not to be erased until any CAN communication trouble codes in the central electronic module (CEM) and any trouble codes in the brake control module (BCM) are remedied and erased.
Therefore, first read the diagnostic trouble codes in the central electronic module (CEM) and the brake control module (BCM), perform troubleshooting and remedy as necessary. If no diagnostic trouble codes (DTCs) are stored, fault-trace the controller area network (CAN) as follows. This diagnostic trouble code (DTC) can then be erased.
For further information on this diagnostic trouble code, see Diagnostic trouble code (DTC) information.

Other information
- General information about fault-tracing in the CAN network Initial Inspection and Diagnostic Overview





Continue - FAULT FOUND

-------------------------------------------------