Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P090368

Condition
The solenoids are controlled by power stages in the transmission control module (TCM). The transmission control module (TCM) opens the power stages to activate the solenoids and sends a voltage through the circuit.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The measured current value is higher than permitted in the circuit for solenoid SLU.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Control signal lead short-circuited to voltage.
- Linear pressure solenoid not working.
- Internal fault in the transmission control module (TCM).

Fault symptom[s]
- Driving/Engine stalls/During deceleration
- Driving/Hesitates/surges/During deceleration