Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P089500

Condition
Transmission shifting and the lock-up function are controlled by the transmission control module (TCM) activating the solenoids in a specific pattern. Shift solenoids S1-S2 are activated depending on which gear the control module has chosen. The control module then adjusts how engagement occurs by controlling the hydraulic pressure linearly via linear solenoids SLT, SLU, SLC1, SLC2, SLC3 and SLB1. The basic parameters for the various gear shifting points are the position of the accelerator pedal (AP) and the vehicle speed, while the shifting quality is determined with the aid of the torque control. By reading off the changes in engine speed (RPM) on the transmission input shaft during the shifting process and comparing with the values calculated in the transmission control module (TCM), the pressurization of clutches and brakes can be adapted.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Too little time between shifts.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Normal driving.





Substitute value
- Auxiliary program Emergency mode 2 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Emergency Mode In Case of Malfunction

Possible source
- Mechanical fault in the transmission.
- Hydraulic fault in the transmission.

Fault symptom[s]
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication
- Text window and warning symbol/Yellow symbol and text message
- Automatic transmission/No automatic gearshift
- Automatic transmission/Vibration
- Driving/Poor performance/lacks power
- Automatic transmission/No manual gear shift
- Automatic transmission/Shifts rough or jerky/Unsure when/at all times
- Automatic transmission/Gear changes take too long to complete/Unsure when/at all times
- Automatic transmission/Lockup does not work