Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P061400

Condition
Information about the vehicle configuration is sent on the CAN network.
Depending on the model and equipment, the vehicle can be configured in different ways.
The central electronic module (CEM) sends the applicable signal ID for the vehicle.
The Transmission control module (TCM) compares this ID with the ID internally stored in the software.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- These do not correspond, which means that the software in the Transmission control module (TCM) is not compatible with other software in the vehicle.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Auxiliary program Emergency mode 3 in the transmission control module (TCM) has started.

Hint: Emergency mode in case of malfunction, B6304T4, TF-80SC AWD, B5254T5, TF-80SC Emergency Mode In Case of Malfunction

Possible source
- Faulty software in the transmission control module (TCM).

Fault symptom[s]
- Text window and warning symbol/Yellow symbol and text message
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication
- Automatic transmission/No automatic gearshift
- Automatic transmission/No manual gear shift
- Automatic transmission/Lockup does not work
- Automatic transmission/Shifts rough or jerky/Unsure when/at all times
- Automatic transmission/Shifts occur too early, too late, too often/Unsure when/at all times
- Driving/Poor performance/lacks power