Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-P023800

Condition
Engine control module (ECM) checks the signal from the boost pressure sensor which is located between the turbocharger and the throttle module.

Note! The boost pressure sensor and air temperature sensor are integrated in the same component, the boost pressure sensor.

The diagnostic trouble code (DTC) is stored if the control module detects that:
- The direct voltage is higher than 4.902 V.
- Incorrect value lasts longer than 9 seconds.
- Incorrect value lasts for 2 or more subsequent driving cycles.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Initial boost pressure or a calculated boost pressure is used.
- Fuel trim disabled.

Possible source
- Contact resistance and oxidation in the terminals.
- Short-circuit to supply voltage in the signal cable.
- Open-circuit in the signal cable.
- Damaged boost pressure sensor.

Fault symptom[s]
- Malfunction indicator light (MIL), on