Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information PBM-C200711

Condition
Park Brake Module (PBM) supplies voltage to right brake caliper directly via an output.
The control module checks the power level on the output.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- DC voltage is less than 3.9 V when the output is not active.
- Incorrect signal lasts longer than 0.1 seconds.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition position 0, I and II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- The signal cable is short-circuited to ground.
- Damaged brake caliper.

Fault symptom[s]
- Information lamp is on
- Message in information display
- Electrical parking brake; Reduced Functionality