Fault-Tracing Information

Fault-tracing

Checking the status




To diagnose the diagnostic trouble code (DTC), the vehicle must be driven at a speed above 2 km/h.
Test drive the vehicle and then read off the fault status of the diagnostic trouble code (DTC) without switching off the engine.

Check whether the fault is permanent or intermittent. Read off the diagnostic trouble code (DTC) fault status when the diagnostic status is "Completed".
The fault is permanent if the fault status is "Fault found".
If the status is "No fault found" this indicates that the fault is intermittent.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




- Ignition off.
Check the connectors. Check for loose connections. Check for contact resistance. Check for oxidation.
Check the signal cable with regard to open circuit.
Take readings between:
- Suspension module (SUM) terminal C1-#12 and ground.
Voltage should be approximately 2.5 V with the car body in the resting position.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Suspension Module (SUM)
- Signal specification Signal Specification, Suspension Module (SUM)
- Component specification [1][2]Specifications
- Location of components Locations
- Checking the supply voltage/ground terminal Component Tests and General Diagnostics
- Checking wiring and terminals Checking Wiring and Terminals. Permanent Faults









Continue - Verification

-------------------------------------------------

Diagnostic trouble code (DTC) information

FAULT-TRACING FAILED - DONE

Attempt New Test - Fault-tracing information

-------------------------------------------------

Verification




Verification

Hint: After repairing, it is necessary to check that the malfunction has been fixed.








- Ignition off
- Reinstall the connectors, components etc.
- Test drive the vehicle and then read off the fault status of the diagnostic trouble code (DTC) without switching off the engine.

Note! The scope of the test drive can vary and must be adjusted according to the conditions for the test in diagnostic trouble code (DTC) information.

Check that the diagnosis is "Implemented" and that the trouble status is "No malfunction found". If the trouble status is "Malfunction found", this indicates defective function.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Diagnostic trouble code (DTC) information

VERIFIED - FAULT FOUND

-------------------------------------------------