Fault-Tracing Information

Fault-tracing

Checking the voltage
Check that the camera is installed correctly to Forward Sensing Module (FSM).
If the camera is connected correctly:
Measure the voltage in the cable harness to the camera. The voltage should be approx. 4.2 - 4.6 V.
If the correct voltage is not measured, replace the forward sensing module (FSM).
If the correct voltage is measured, click Continue.

Other information
- Camera collision warning Camera Collision Warning
- Collision warning control module, L.H.D Service and Repair






Continue - Erase diagnostic trouble codes

-------------------------------------------------

Erase diagnostic trouble codes
Disconnect the battery terminal and reconnect it after approx. 2 minutes.
Restart the vehicle.
Erase diagnostic trouble codes (DTCs).

Does the diagnostic trouble code (DTC) recur?

Yes - Corrective actions

No - FAULT FOUND

-------------------------------------------------

Corrective actions

If the diagnostic trouble code (DTC) reappears, rectify in accordance with the following priority:
- Replace the cable harness between camera and control module.
- Replace the camera.
- If the diagnostic trouble code (DTC) reappears after replacing the cable harness and camera then the forward sensing module (FSM) needs to be replaced.

Continue - DONE

-------------------------------------------------