Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BCM-C100064

Condition
The control modules transmit and receive information via a standardized serial communication method - CAN (Control Area Network). The control modules transmit information on the controller area network (CAN), which other systems can use. The Brake control module (BCM) retrieves the information that can then be used in different brake functions. The Brake control module (BCM) checks that the communication is correct via an internal diagnostic test mode (DTM).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The calculated gear does not correspond with the gear in the CAN information received.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- The Hill descent control (HDC) function is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- Disruption or intermittent open-circuit on the Control area network (CAN).
- Contact resistance or oxidation in the terminals or connections.
- Faulty reversing light switch.
- Faulty switch gear 1.
- Fault-trace the central electronic module (CEM).

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- Hill descent control/Does not work