Fault-Tracing Information

Fault-tracing

Calibration
Calibrate Brake control module (BCM) according to information under Diagnostics/vehicle communication.
Remedy as necessary.





Continue - Reading off the status of the diagnostic trouble code (DTC)

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Calibration

-------------------------------------------------

Reading off the status of the diagnostic trouble code (DTC)
- Ignition on.
- Wait 1 minute.
- Read off diagnostic trouble codes (DTCs).
Check that the current DTC has disappeared or changed status from permanent to intermittent fault.

Other information:





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - Verification

No - Fault-tracing information

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reconnect the connectors, reinstall components etc.
- Test drive the vehicle following:
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------