Fault-Tracing Information

Fault-tracing

Checking the wiring








- Ignition off
- Disconnect the antenna connector.
Check the terminal. Check for contact resistance. Check for loose connections. Check for oxidation.
Checking the antenna cable between the remote digital audio receiver (RDAR) and the satellite antenna for open circuit.
Remedy as necessary.

Other information
- Location of components Component Location, Remote Digital Audio Receiver (RDAR)
- Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring and Terminals. Permanent Faults

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the radio is working and that the reception is acceptable.

Is the radio playing through the loudspeakers?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the wiring

-------------------------------------------------