Fault-Tracing Information

Fault-tracing

Fault-tracing information
A possible cause for the generated DTC is that the window lifts have been activated using the diagnostic tool at a workshop. The DTC can be erased and ignored.

Do you wish to continue with fault tracing?

Yes - Checking software

No - DONE

-------------------------------------------------

Checking software
The control module has registered an internal fault. In the event of a permanent fault, try downloading new software to the control module. Erase the diagnostic trouble code (DTC). Check to see if the diagnostic trouble code (DTC) recurs.

Does the diagnostic trouble code (DTC) recur?

Yes - Replacing the control module

No - DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------

Replacing the control module
The DTC indicates a damaged component in the rear door control module.
Replace the control module. Check that the fault has been rectified by performing a new test for the DTC.

Other information
- Rear Door Module (RDM) Rear Door Module (RDM)
- Signal description, driver's door module / passenger door module (DDM/PDM) Signal Description, Driver's Door Module / Passenger Door Module (DDM/PDM)
- Location of components Locations

Has the fault been remedied?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------