Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-B113C15

Condition
The central electronic module (CEM) supplies voltage to the lighting in the switch for flashing hazard lights.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Signal too high from the output.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Control module supplied with power.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- The function switches off permanently after 100 operating cycles where the fault was detected. Erasing diagnostic trouble codes (DTCs) resets the result.

Possible source
- Open-circuit or short-circuit to supply voltage in the signal cable.

Note! For some unknown reason, this diagnostic trouble code may be generated. If no fault is found during troubleshooting, delete the diagnostic trouble code.

Fault symptom[s]
- Non-definable symptom