Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-B110112

Condition
The Central electronic module (CEM) checks the output signal to the relay coil for relay, comfort.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Signal too high from the output.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Activated relay.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

This diagnostic trouble code (DTC) is never stored on its own.

Substitute value
- The function (the output) turns off during the driving cycle when fault is detected. The function (the output) switches off permanently after 100 operating cycles where the fault was detected. Erasing trouble codes as well as start of new driving cycle resets the output.

Possible source
- Damaged relay.
- Short-circuit to supply voltage in the relay circuit.

Fault symptom[s]
- Air flow problem
- No recirculation
- Poor air quality in the passenger compartment