Fault-Tracing Information

Fault-tracing

Checking the diagnostic trouble codes (DTCs)
Power supply, folding of door mirror and power supply, motor blocked lock position split cable inside control module. Therefore, this DTC is always generated in pairs with corresponding DTC for power supply for door mirror folding.
Sometimes, the DTC may also be generated due to an error that initially must be detected/handled by another DTC/other DTCs. Check that DTC(s) are generated in the control module for the following faults:
- Power supply, folding of door mirror has short-circuit to ground.
- Power supply, common lock motor has short-circuit to voltage or open-circuit.
- Power supply, folding of door mirror has short-circuit to voltage or open-circuit.
Perform fault tracing first according to this/these DTC(s). Return to this fault tracing if no relevant DTCs are found, or if the fault persists.

Other information
- Description of frozen values Description of Frozen Values, DDM/PDM
- Description of status identifier Description of Status Identifier
- Description of counter Description of Counter

Do you wish to continue with fault tracing?

Yes - Checking the power supply

No - DONE

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------

Checking the power supply
Fault trace power supply, motor blocked lock position regarding:
- Short-circuit to supply voltage.
- Open-circuit in the cable.
- Contact resistance, oxidation or poor contact in connections.
Fault trace power supply, folding of door mirrors regarding:
- Short-circuit to supply voltage.
- Open-circuit in the cable.
- Contact resistance, oxidation or poor contact in connections.

Other information
- Signal description, driver's door module / passenger door module (DDM/PDM) Signal Description, Driver's Door Module / Passenger Door Module (DDM/PDM)
- Checking wiring and terminals Checking Wiring and Terminals. Permanent Faults
- Connecting the breakout box Connecting Breakout Box, Driver Door Module / Passenger Door Module (DDM/PDM)
- Location of components Locations

Was a fault detected?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------