Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-B10A211

Condition
The Central electronic module (CEM) checks the collision signal from the Supplemental restraint system module (SRS)
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The diagnostic trouble code (DTC) is stored if the control module registers that the signal is too low.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- None.

Possible source
- The signal cable is short-circuited to ground.
- Incorrect voltage supply to the supplementary restraint system (SRS).

Fault symptom[s]
- Message in display