Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-10A200

Condition
The Central electronic module (CEM) checks the collision signal from the Supplemental restraint system module (SRS)
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The control module registers a collision signal.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- None.

Possible source
- The control module registers a collision signal.

Fault symptom[s]
- Engine is difficult to start
- Malfunction indicator light (MIL), on
- Message in information display