Fault-Tracing Information

Fault-tracing

Checking components and connections








- Ignition off, wait for 15 seconds.
Replace the occupant weight sensor (OWS).

Note! After replacing the occupant weight sensor (OWS), the occupant weight sensor (OWS) must be calibrated.

Other information
- Occupant weight sensor (OWS): Signal specification Signal Specification, Occupant Weight Sensor (OWS)
- Supplemental restraint system module (SRS): Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Front passenger weight sensor Removal and Replacement
- Calibrating the occupant weight sensor (OWS) Testing and Inspection

Continue - Verification

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking components and connections

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------