Part 4

Parking assistance, front, chassis number 97000-















































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Parking assistance, front, chassis number 97000-

Applies to right-hand drive cars




- Route the cable over to the right-hand side of the car and further back along the existing cable harness backwards and into the cargo compartment.
- Position the cable so that is does not get trapped or damaged.





- Route the cable alongside the car's cable harness.





- Connect the routed cable to the centre connection on the parking assistance module (PAM).

Note! Make sure that the connector clicks into place and is properly secured.



















Note! The cradles must be installed facing in the direction as shown in the figure.

- Press in the cradle on the bumper cover.
- Repeat the steps for the other cradles.






Note! The large grey connector must be on the right side of the bumper cover. On right-hand drive cars it must be on the left.














- Secure the end of the cable harness at the sensors to the bumper cover using butyl tape.





- Secure the cable harness to the bumper cover using butyl tape.





- Hold the bumper up against the car and connect the connector for the sensor cable to the connector at the car.
- Secure the assembled connector on the member (1). Use a tie strap on each side of the connector
- Connect the connectors to the fog lamps, if installed.
- Slide the bumper cover into the correct position





- Guide the lower edge of the bumper cover into the guides
- Reinstall the bumper cover.
- Reinstall the engine splash guard.
- Reinstall the detached components in reverse order.
- Load securing eyelets, tightening torque: 24 Nm (17 lbf.ft.).





- Download software (application) for the accessory's function