Part 3

Parking assistance, front, chassis number 97000-















































INTRODUCTION
- Read through all of the instructions before starting installation.
- Notifications and warning texts are for your safety and to minimize the risk of something breaking during installation.
- Ensure that all tools stated in the instructions are available before starting installation.
- Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
- In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.






Parking assistance, front, chassis number 97000-




- Locate the hole for the rubber grommet under the insulation panel.
- Make a small cut in the insulation panel starting just above the hole, continue to the center of the hole and then straight down.





- Push the carpet tabs to one side to access the rubber grommet in the cowl panel.
- Remove the rubber grommet.






Note! Applies to cars with fuel powered parking heaters. Protect the coolant hose on the horizontal connection of the water pump when making the markings for holes.

- Pierce holes through the insulation and out into the engine compartment, for hole-marking.





- Raise the car.
- Cut out a hole in the heat insulation that is approx. 20 mm (25/32 ") larger than the size of the rubber grommet.





- Take the rubber grommet from the kit and cut the top off the smaller rubber nipples
- Lubricate the rubber grommet. Use low temperature grease (P/N 1161417).
- Thread the rubber grommet onto the cable harness.
- Route the cable harness through the hole and press in the rubber grommet in the hole so that it seals properly.
- Pull the cable harness so that the correct length remains in the engine compartment.
- Make sure that the cable harness heating hose is in contact against the rubber grommet and secure it with a cable tie.





- Lower the car.
- Release the catch on the connector that was taped.
- Connect the pre-routed cable harness terminals in the connector as follows:
1. Blue (BL)
2. Green (GN)
3. Violet (VO)
4. Yellow (Y)
5. White (W)
6. Black (SB)
- Press back the connector's catch.





- Take the long cable harness from the kit. Connect it to the connector.
- Route the cable harness from the lower edge of the A pillar and further back at the sill and under the carpet.
- Fold back the carpet and screw the clip into place.





- Route the cable between the floor carpet and the sill. Position the cable so that it is not trapped or damaged.

Applies to left-hand drive cars




- Route the cable along the existing cable harness backwards and into the cargo compartment.
- Position the cable so that is does not get trapped or damaged.